Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Hood

1995-1999 Chevrolet Hood Release Lever Mount

3 downloads252 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Weston Graham (Tator_Soldier)

Description

This is a replacement for the hood latch level mount on the 1995-1999 chevy vehicles. Both of the ones on my 1999 and 1996 Tahoe were broken at the bolt mount, printing these are pretty easy. How to: Remove physical handle from old latch assembly, along with spring without damaging it, and place onto newly printed mount. Secure the spring with the "chevy stopper" part with a few drops of super glue. Then place the "glue square" in through the new mount (wide end sits on top of the mount face) and super glue that in. Then put into slot and replace bolt. Do not over tighten.