Files (2)

1999_Mitsubishi_Eclipse_-_wheel.stl

STL

445.2 KB

1999_Mitsubishi_Eclipse_-_body.stl

STL

751.9 KB

Print guidance estimate

Uses saved filament metadata

Print cost & setup estimate

Saved filament data plus editable planning inputs for cost and time.

2 model files

Recommended kit

50g

Based on 25% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Reference shelf

Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Unsure which one fits? Read the automotive filament guide.

Exterior

1999 Mitsubishi Eclipse

0 downloads200 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

2 hosted model files

STL

Material start

PETG or ASA for durability in outdoor conditions

Saved part guidance

Strength start

20-30% infill for a balance between weight and strength

Saved part guidance

Orientation / supports

Likely not needed

Exact totals

50 g · 2 hours

Saved estimate

Vehicle exposure

UV/weather exposure — ASA is the starting point

Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Michael Chen

Verified

Description

My remix of the original Mitsubishi Eclipse model included a lot of fixes original model sits at a weird angle, not flat or horizontal (it's tilted along the long axis), so I rotated it a bit. I didn't get it quite perfect but it's good enough for smaller scale prints, not sure if it will be noticeable on larger scales. front bumper cover hanging quite a bit lower than the body of the model, and this means most of the model sits on supports if you print it as is. This really prints very poorly in my opinion, so I opted to trim off much of the underside to create a mostly flat bottom so it's mostly flush with the print surface. This prints much more easily on an FDM printer upper parts of the front wheel wells aren't cut out enough to actually fit these wheels properly, so I had to cut out more of a relief in there. wheels looked pretty awful being empty cups, so I took another wheel model and merged it with this one to create close to an OEM look. Still hollow so they look like real wheels, pretty cool if you ask me. At a small scale even with the overhang (i.e. no supports) for the spokes they print pretty well but this might have an issue on larger prints.