2015 Ram 1500 Trash Bin

0 downloads54 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

Source link only

No hosted model files

Material start

PETG or ASA for durability in hot car conditions

Saved part guidance

Strength start

100% infill for the lid, less infill may be sufficient for the base

Saved part guidance

Orientation / supports

verify in slicer

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

Cabin/interior use; avoid high-heat zones

Download the model at its source, then confirm the format is supported by your slicer. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

Download at source

License & use

CC BY-NC

Link-only

Attribution required

Safety/IP review

Files stay with the original publisher; this catalog entry does not grant hosting or resale rights. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

My truck has a nice big center console storage area, but I tend to fill it up with random trash (candy wrappers, receipts, etc.). To keep the garbage from completely taking over the area, I printed myself a trash bin that contains it to a smaller area. It fits nicely into the bottom of my center console and is sturdy enough that I can pile things on top of it if I want. Mine is printed in PETG since it's going to be in the truck on hot days. I printed the lid with 100% infill for strength. You could probably get away with less, but it's not that much plastic. I did have to slightly trim the posts that connect the lid to the bin. I just took a tiny bit off the sides of them with my side cutters and they work perfectly. The base of mine did warp slightly, but it still sits in the console fine so it doesn't bother me too much. Also, be aware that the lid STL is bit on the large side because I went overboard with the quality of the logo. Obviously prints fine, but it may take longer to slice than you would expect. My truck is a 2015 with bucket seats. It will probably fit other years if they have the same dimensions for their center console, but I can't make any promises.