Files (1)
Reference shelf
Recommended filament for this print
Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.
| Referenced item | What to verify | Price & availability |
|---|---|---|
| PETG filamentAmazon · Affiliate link | Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region. | Check price at Amazon |
| ASA filamentAmazon · Affiliate link | Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability. | Check price at Amazon |
Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.
2015+ Subaru WRX accessory button cable passthrough
License & use
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
3DPrintedCarPartDescription
This is a replacement for the OEM accessory button in 2015+ Subaru WRX’s to allow a cable of your choosing through. Fitment is only confirmed on the 2020 WRX but I believe it is the same from 2015 and up —To remove the OEM placeholder is a bit of a pain but not to hard.— There are small detents on the insert itself that click in on that accessory panel. There are 2 on top and 1 on the bottom when looking at it from behind. The best way to get the OEM insert out is to get 2 thin pieces of something and wedge one on top and one on the bottom and the push from the front of the insert inward and maybe wiggle until it slides out. Its tight so take your time. Once its out the 3d printed one sits securely but will easily push back out. Filament: Matterhackers MH-build ABS Infill: 20% Nozzle temp: 260 Bed Temp: 110 Layer Height:.16 Cooling: off Plate adhesion: Brim Wall line count: 3
Compatible Vehicles
Originally published on thingiverse.com by Jeff Taylor (jmarlowet) · License: CC BY
Browse categories
Browse other part families
Jump to interior, exterior, accessories, dashboard, mechanical, or tools hubs when you need a different kind of replacement part.
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
