3rd Generation Honda Odyssey Magnetic Vent Mount, er, Mount - image

Files (1)

odyssey_vent_mount_dock_v2.stl

STL

177.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
odyssey_vent_mount_dock_v2.stl	Mount / bracket	177.4 KB STL	Slice file	Slice file	Slice file	Ensure a clean and dry print bed for optimal adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

3rd Generation Honda Odyssey Magnetic Vent Mount, er, Mount

0 downloads262 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill with 1.2-1.6mm walls

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY-SA

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

I love the magnetic dash mount for my phone (Logi Zerotouch) but I hate that it blocks my A/C vent (I live in Florida). I also wanted the phone oriented in a place that was reachable and doesn't block anything else in my dash and didn't require hardware to mount. Yeah, a lot of requirements, no? Well, I finally tinkered around and found that I could clip a mount onto the dashboard trim of my 2009 Odyssey without using hardware and here is the result. It's easy to remove the dashboard trim. Just open the upper glove box and use a trim tool or an electrical tape covered screwdriver to pry the trim from the dash where it meets the dash at the glovebox opening. Then you slide the clip on the back of the mount onto the trim between the navigation screen (or radio depending on your model) and the dash trim and push the dash trim back on. I find that it's not wobbly but if you do, you can put some double side tape on the bottom of the mount to affix it to narrow flat part of the trim on top. Theoretically this should work on any 2005-2010 Odyssey (3rd generation). This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/8z1904N7y1P