Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon
ABS filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ABS; use an enclosure and suitable ventilation, and verify temperature requirements and seller.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Vents

73-79 F-Series and 78-79 Bronco A/C & Heater Duct Adapters

0 downloads189 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Dan Green (danverde)

Description

I initially tried to print this https://www.thingiverse.com/thing:3887203 but it didn't work out so I designed my own that doesn't require supports. I use the same hose that is referenced in the other build. I also added a set of adapters for the drivers side vent. The angled drivers side adapter does require supports under the outlet that hangs over the build plate. Dorman 708-083 Use ABS or PLA or other high temp material as suggested sas64.