82-92 Camaro/Firebird Rear Interior Trim Nut

This is a direct replacement for the nylon trim nuts that hold the hatch area panels on. Nut.stl is for the 6 plastic screws that reatin the spare wheel cover and rear panel. Push-Pin_Nut.stl is for the three 8mm push pins that retain the driver side panel. You will need to print two Clip.stl per Nut.stl/Push-Pin_Nut.stl. Push the two clip pieces into the main body from the underside, they should be a tight friction fit and should not require glue. If they cannot be inserted by hand or with mild squeezing from pliers, check your horizontal expansion and other dimensional accuracy related settings. Wiggle assembly up and down while pushing into the back of the holes during installation.