Amazon Echo Auto mount for Mercedes GLA, CLA and others - image

Files (1)

Echo_Auto_GLA.stl

STL

79.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Echo_Auto_GLA.stl	Primary model	79.1 KB STL	Slice file	Slice file	Slice file	Print with the base facing down to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Amazon Echo Auto mount for Mercedes GLA, CLA and others

0 downloads175 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for durability and heat resistance

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for a balance between strength and weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This gadget perfectly fits into my Mercedes Benz GLA. I used two 12 x 2mm Neodym magnets which hold the Echo Auto in place. The USB cable is about 10 inches (25 cm) long. The STL file was updated after I shot the photos. The Echo's position came a bit more in front now. Print the object as shown in the photo. You have to turn it by 90° to reduce the support.