Chevy Colorado/GMC Canyon Front Pocket AMPS Dock - image

Files (3)

pocket_dock-long-lower.stl

STL

58.7 KB

pocket_dock-med-lower.stl

STL

58.5 KB

pocket_dock.stl

STL

52.9 KB

Print plan

Exact totals not supplied

Print setup plan

Useful setup guidance without pretending STL byte size can predict filament, cost, or print time.

3 model files

Material plan

PETG / ASA

Published material guidance; still check heat, UV, load, and printer compatibility.

Starting setup

25% infill

A planning starting point only; wall count, orientation, and geometry often matter more than infill.

Final totals

Confirm in slicer

Choose the needed variant, then slice it for grams, cost, and print time.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Reference shelf

Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Unsure which one fits? Read the automotive filament guide.

Dashboard

Chevy Colorado/GMC Canyon Front Pocket AMPS Dock

0 downloads281 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

3 hosted model files

STL

Material start

PETG or ASA for durability in a car environment

Saved part guidance

Strength start

20-30% infill for a balance between strength and weight

Saved part guidance

Orientation / supports

verify in slicer

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

High cabin heat — validate PETG or choose ASA/ABS

Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

The tiny front pocket in the dash of the '15 and up Colorado is nearly useless. Even if you shove a wallet or garage door opener in there it'll slide right out if you hit the gas at all. This 'pocket dock' for phone or tablet gives it some purpose. To use the dock you'll want 10lb 'poster' tape - the kind that is a mm or two thick. Place a piece on the top and bottom flat parts, pinch, and insert into the dock. The hole pattern matches industry standard AMPS. Once appropriately installed it is pretty locked in. You're more likely to rip the phone from the mount than the dock from the pocket. There are three different versions. the base version sits very close to the dock edge and is appropriate for RAM ball style docks or other longer, positionable docs. The medium-lower dock hangs below the pocket and is appropriate for most phones and likely horizontal tablets. The 'long' version is good for lower profile docks (eg: magnetic).