Citroen C3 Picasso doorcap

I lost, somehow, the cap from the door handle of my Citroen C3 Picasso. They are absolute expensive to replace, if you can find them at all. I only need the cap with the keyhole, not a complete set. A fimo clay solution worked fine for some years, but cracked eventually. I needed another diy solution. I tried scanning a cap without keyhole, but this was a drag. So this is my first Fusion 360 project. Since I never ventured beyond Tinkercad, this had quite a steep learning curve for me. Took some instruction video's to get a hang for the basics. After some practices it took me about an hour to model it from scratch. It took me many hours to do the preliminary practices. I finished this project within a week, so I'm pretty pleased.