Civic Type R License Plate Bracket Mount - image

Files (2)

CivicTypeR_Front_Plate_-_Front_bracket.stl

STL

3.4 MB

CivicTypeR_Front_Plate_-_Rear_bracket.stl

STL

1.1 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
CivicTypeR_Front_Plate_-_Front_bracket.stl	Mount / bracket	3.4 MB STL	Slice file	Slice file	Slice file	Ensure proper orientation in slicer for optimal print quality
CivicTypeR_Front_Plate_-_Rear_bracket.stl	Mount / bracket	1.1 MB STL	Slice file	Slice file	Slice file	Ensure proper orientation in slicer for optimal print quality

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Front Bumper

Civic Type R License Plate Bracket Mount

0 downloads75 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

2 hosted model files

STL

Material

PETG or ASA

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill with 2-3 walls for durability

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This bracket allows you to mount the front plates onto the car without having to drill the front bumper. Back piece slides though the front grill, and has holes for a zip tie so that can be used to prevent it from falling and become lost behind the grill. Back plate from amazon or Canadian tire 7$ CDN, spaced holes according to specs, but the plate I bought was off by about half a cm; nothing a drill and clippers couldn't fix. You will need to print the following (I didn't use supports): 2 Rear Brackets 1 Front Bracket Plate: http://canadiantire.ca/en/pdp/license-mounting-plate-black-0377420p.html. Screws / Bolt: 1/4-20.