Files (2)
Reference shelf
Recommended filament for this print
Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.
| Referenced item | What to verify | Price & availability |
|---|---|---|
| PETG filamentAmazon · Affiliate link | Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region. | Check price at Amazon |
| ASA filamentAmazon · Affiliate link | Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability. | Check price at Amazon |
Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.
Cupra Charger Holder (Cupra Leon 4KL)
License & use
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
3DPrintedCarPartDescription
I was frustrated by having the Hybrid EV charging cable and "brick" lying around on the floor, so I quickly drew up a holder for the charging brick. For wall mounting you can also add some washers between wall and holder, so the Charger stays nice and cool. The charger is probably comparable or the same for all of VWs Hybrids for the current model year 2021 / 2022 (so e.g. VW GTE, Skoda Octavia RS iV, Cupra Formentor, etc.). Additionally I used the the nice EV Type II Plug and Cable Holder from mat_neu27 -- > https://www.thingiverse.com/thing:4153588 Printing: The part is cut in half to ensure printing without a lot of supports. I recommend laying the parts on the side wall (without the hexagonal cutouts). In that case you will just need some supports for the first few layers, depending on your layer height. My settings (Cura): - Nozzle Size: 0.5mm - Layer Height: 0.4mm - Printing Speed 60mm/s (1st layer 30mm/s for adhesion) - 3 walls - 15% infill Gyroid - Support overhang Angle: 55 - 60 degrees Printing time ~3.5 hours per part.
Compatible Vehicles
Originally published on thingiverse.com by Frederick Stober (iFreddy12) · License: CC BY
Browse categories
Browse other part families
Jump to interior, exterior, accessories, dashboard, mechanical, or tools hubs when you need a different kind of replacement part.
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Most specific car + model + year + category matches first, with popular parts mixed in.
