Files (1)

dashtrimrepair_f150_v11.stl

STL

8.1 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

Based on 25% main infill across listed model files

Material cost

$0.22

Filament only at roughly $24/kg PETG / ASA

Print time

15m–26m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
dashtrimrepair_f150_v11.stl	Primary model	8.1 KB STL	8g $0.20	9g $0.22	20g $0.47	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

dashTrimRepair_f150_v1.1

0 downloads42 views0 likes

Shared by

Alfred

Verified

Description

This is a repair part for the dashboard trim panels on a 1992-1996 Ford F150-F350. Broken tabs can be ground from the rear of the trim part and these replacement clips epoxied in place. The existing small metal retaining clips should be removed from the old part and placed on the new tabs. This is Prototype #2. The tab height has been increased +2mm and a hole has been inserted at the bottom center of the tab to better accommodate the metal clip. This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/bEglwK5CRKZ