DS3 52mm gauge holder for 2" boost/oil/water gauge - Suporte Manômetro DS3

Print setup recommendations

• Material: PETG or ASA for durability and heat resistance
• Infill: 20-50% infill for a balance between strength and weight
• Supports: verify in slicer
• Use the original rubber grommets from the air directional for a secure fit
• Drill a hole in the ventilation housing to pass the gauge wiring
• Invert the piece 180 degrees on the X-axis to avoid printing supports
• Ensure proper layer adhesion and cooling for a strong and durable print