Files (1)

fiat_500_door_speaker.stl

STL

583.5 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

24g

Based on 25% main infill across listed model files

Material cost

$0.59

Filament only at roughly $24/kg PETG / ASA

Print time

42m–1.2h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
fiat_500_door_speaker.stl	Primary model	583.5 KB STL	22g $0.54	24g $0.59	54g $1.28	Ensure a strong bond between the adapter and the door for secure speaker mounting

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Door Panels

Fiat 500 Door Speaker Adapter

0 downloads160 views0 likes

Shared by

Alfred

Verified

Description

This is a simple bracket that will mount a 6.5" speaker in a Fiat 500 door. Below are some caveats about this install specific to the Fiat. * The stock speakers have rivets that must be drilled out. * There is no way to get behind the speaker without removing the vapor barrier. The mount as pictured was bolted in place; this install process will require getting behind the vapor barrier. Another solution I'm looking into is installing rivet nuts so the speaker can be accessed simply by removing the door panel. * The wires to the speaker come from the front; I did not accommodate for this in my design. * Some of the four inner bolts have metal behind them. * Stock speakers in the Fiat are very efficient; I wouldn't recommend replacing them without being prepared to get a new amp as well. * In my install I sealed the door to make it behave more like a speaker box. This dramatically increased the bass from the doors but I have developed a rattle already. I will update this if I have to alter the design.