Fiat 500 / Ford Ka Suspension Strut Top Cover

Print setup recommendations

• Material: PETG or ASA
• Infill: 20-30% infill for durability, with 1.2-1.6 mm walls
• Supports: verify in slicer
• Print with the rib in the centre 'peg' facing downwards for easier support removal if needed
• Use a 0.4 mm nozzle or smaller for smoother results
• Adjust layer height to 0.2 mm or smaller for better surface finish
• Ensure the part is securely fastened to the suspension strut centre bolt