Ford F250 Automatic Transmission Shift Indicator Cable Bracket Clip - image

Files (3)

Adjuster_Clip.3mf

3MF

14.7 KB

Adjuster_Clip_Binary.stl

STL

45.2 KB

Adjuster_Clip_ASCII.stl

STL

241.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Adjuster_Clip.3mf	Clip	14.7 KB 3MF	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
Adjuster_Clip_Binary.stl	Clip	45.2 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation for minimal supports
Adjuster_Clip_ASCII.stl	Clip	241.6 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation for minimal supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Ford F250 Automatic Transmission Shift Indicator Cable Bracket Clip

0 downloads86 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

3 hosted model files

STL + 3MF

Material

PETG or ASA

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill with 1.2-1.6 mm walls

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY-SA

Commercial use allowed

Attribution required

Safety/IP review

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This was designed for my 2003 Ford F250 Super Duty But it looks like it fits many fords, Lincoln's and Mercury models. The Shift Indicator was off so I found a commonly broken plastic part on the steering wheel column under the lower dash panel. It holds the housing for the shift indicator cable and has an adjustment wheel on it to diel in were it lands when in gear. I designed this part because it was hard to get from ford at the time. It has been on my Dailey driver truck for 4 months with no issues.