Ford Focus ST center console tray - image

Files (1)

Ford_Focus_center_console_tray_with_ST_logo_v2.stl

STL

107.8 KB

Print plan

Exact totals not supplied

Print setup plan

Useful setup guidance without pretending STL byte size can predict filament, cost, or print time.

1 model file

Material plan

PETG / ASA

Published material guidance; still check heat, UV, load, and printer compatibility.

Starting setup

25% infill

A planning starting point only; wall count, orientation, and geometry often matter more than infill.

Final totals

Confirm in slicer

Slice the selected model with your final material, orientation, walls, and supports.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Reference shelf

Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Unsure which one fits? Read the automotive filament guide.

Center Console

Ford Focus ST center console tray

0 downloads6 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

1 hosted model file

STL

Material start

PETG or ASA for durability in car conditions

Saved part guidance

Strength start

20-30% infill for a balance of strength and weight

Saved part guidance

Orientation / supports

verify in slicer, but likely needed for the small ledges/tabs at the top

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

Safety/IP review

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a remix of the Focus RS console tray by majingrim here: https://www.thingiverse.com/thing:3769851 I also used the ST logo text created by JackHydrazine here: https://www.thingiverse.com/thing:3849541 (but scaled down to 80% size) This should fit 2015-2018 Ford Focus STs. The "ST" text is very slightly lower (~0.5 mm) than the surrounding bottom of the tray, but it is clearly visible. I figured this would be a good depth to avoid trapping too much dirt and also allow for some contrasting paint in the future. The small ledges/tabs at the top of the part may be a challenging overhang for some printers, so use supports if you you want it to be perfect. I did not use supports and one layer of material was loose/sagging, but is hard to notice unless you look carefully and did not affect the fit in the vehicle. I was told EU vehicles need to have the notch on the other side so there is also a mirrored version (except for the "ST" text).