Files (3)
Published material guidance; still check heat, UV, load, and printer compatibility.
A planning starting point only; wall count, orientation, and geometry often matter more than infill.
Choose the needed variant, then slice it for grams, cost, and print time.
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Reference shelf
Recommended filament for this print
Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.
| Referenced item | What to verify | Price & availability |
|---|---|---|
| PETG filamentAmazon · Affiliate link | Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region. | Check price at Amazon |
| ASA filamentAmazon · Affiliate link | Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability. | Check price at Amazon |
Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.
Unsure which one fits? Read the automotive filament guide.
Galaxy S5 holder for 2007 2WD ford expedition (Replaces coin holder on dash)
Print this part
Use the part context as a starting point, then confirm geometry-dependent values in your slicer.
Files
3 hosted model files
STL
Material start
PETG or ASA for durability in a car environment
Saved part guidance
Strength start
20-30% infill for a balance between strength and weight
Saved part guidance
Orientation / supports
verify in slicer
Exact totals
Slice for grams + time
Model geometry and final settings determine both
Vehicle exposure
High cabin heat — validate PETG or choose ASA/ABS
Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.
License & use
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
3DPrintedCarPartDescription
2WD expeditions from 2007 had a "coin holder" thingy on the dash near the steering wheel, where the 4WD switch would go on the 4WD version. I removed the coin holder from my dash and replaced it with a 3D-printed phone holder. This will likely fit other model year expeditions, but I've only tested it on a 2007. Note: I made the base in separate pieces to be glued together so that it will be stronger. Most parts seem to break along the boundary between layers, so I wanted to have the loading in the springy pieces to be "in plane" for the layers rather than separating them. The clips have several different orientations, so there was not a single position that would accomplish that goal, and the rest of the part made more sense to print in the orientation shown.
Compatible Cars
Originally published on thingiverse.com by Isaac (ivymike) · License: CC BY-SA
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
