Files (1)
Based on 25% main infill across listed model files
Filament only at roughly $24/kg ASA / ABS
Uses 70 mm/s, 0.2 mm layers; verify supports in slicer
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Reference shelf
Recommended filament for this print
Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.
| Referenced item | What to verify | Price & availability |
|---|---|---|
| ASA filamentAmazon · Affiliate link | Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability. | Check price at Amazon |
| ABS filamentAmazon · Affiliate link | Amazon product page for 1.75 mm ABS; use an enclosure and suitable ventilation, and verify temperature requirements and seller. | Check price at Amazon |
Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.
Unsure which one fits? Read the automotive filament guide.
Headrest Hook
Print this part
Use the part context as a starting point, then confirm geometry-dependent values in your slicer.
Files
1 hosted model file
STL
Material start
ASA or ABS
Saved part guidance
Strength start
20-30% infill for durability
Saved part guidance
Orientation / supports
Likely not needed
Exact totals
50 g · 2 hours
Saved estimate
Vehicle exposure
Higher-heat material; verify location and load
Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.
License & use
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
Michael ChenDescription
I find that giving kids a place to put things is the easiest way to get them to organize on their own. I recognized that my daughter had a place for everything in my car except her backpack which ended up on the floorboard where it was inevitably stepped on or forgotten. My solution is this hook. It simply grabs one of the posts of the headrest in front of the car seat. It keeps bags off the floor and gives the little people a roll in keeping the car clean. Print slow and warm for best layer adhesion. I suggest a material like ASA or ABS to take the heat of the car in the sun and maintain the abuse of being used daily.
Originally published on thingiverse.com · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
