Headrest phone holder for Skoda Fabia 2 and Xiaomi Redmi Note 5

A headrest phone holder to allow small babies on the child seats watch fairytales on a mobile phone. This model is designed to be mounted on Skoda Fabia 2 - headrest rods pitch 150mm and rods diameter 15mm. Also, it is designed for Xiaomi Redmi Note 5-inner space is 163x15mm. This is fully sufficient also for phone covers with stand ring behind (see photos). Side holes in the holder are intended for charging the phone and to allow sound to go through holder. Doesn't matter if phone lies left or right side down. If you have same phone (RN5) but without thick back cover, just print one of the aids in the model. The one 60mm long and 5mm thick is intended to be glued on back side (avoid place where phone camera is). This will hold phone on front side of the cover, towards baby. It is, as mentioned, 5mm thick. Just sink it in slicer if you need it less thick. Second aid, looking like a hook, is -yes a hook.;-) It is intended to be attached from top side to the walls to work as a spacer too. You can attach it from sides-if you have different phone-smaller or you can attach it to the back side too. It's walls are 4mm thick and it si more like and idea, you can design yourself better or with different sizes. IMPORTANT: Use fire torch like this: https://www.aliexpress.com/item/New-BBQ-Torch-Turbo-Cigar-Lighter-Spray-Gun-Jet-Butane-Lighter-For-Kitchen-Cigarette-1300-C/32942642242.html to remove sharp edges on it. I think it will be much smoother to do it this way than to solve it in model. Avoid sharp edges in car for safety reasons. Less important 2: print it from PET-G, or something high temperature proof. PLA is not a good idea, if you don't want to see your holder flowing from car;-).