Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Interior

Iveco Daily Mk IV Cabin Filter Intake Mesh

0 downloads259 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

(

Shared by

(Pugwash)

Description

A mesh to fit the cold air intake that leads to the cabin on an Iveco Daily Mk 4. The wire mesh that sits in the rubberised cover was missing from my van. The rubber surround was still there with 8 stubs of rubber where the mesh had been attached. This product fits into the rubber cover and slots over the rim to prevent movement. Although this is in the engine bay, it's also in a constant flow of cold air when moving, so PLA should survive. To allow air through, your printer settings are VERY important to create the mesh. You can change the infill density for a finer or large mesh but 25% seems a good amount.