Jeep Grand Cherokee WK Switch Plate / Panel

0 downloads53 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

Source link only

No hosted model files

Material start

PETG or ASA

Saved part guidance

Strength start

20-30% infill with 1.2-1.6mm walls

Saved part guidance

Orientation / supports

verify in slicer

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

High cabin heat — validate PETG or choose ASA/ABS

Download the model at its source, then confirm the format is supported by your slicer. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

Download at source

License & use

CC BY-NC-SA

Link-only

Attribution required

Files stay with the original publisher; this catalog entry does not grant hosting or resale rights. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

Switch panel that replaces the factory cubby on left side of dash. Fits five 3/4 inch switches made to fit Hella switch #H61923001. The cheap push in rocker switches on Amazon will fit but don't like to stay in, (well at least the ones i have) The part is 1/8 thick. Should fit Jeep Grand Cherokee Wk 2008-2010. Possibly Jeep Commander of the same years. (If someone tries let me know.) Actual part dimensions 144mm long, 58mm tall, 3mm thick, holes 20mm. Not perfect but works good for now. The tabs are a tight fit be careful removing it after test fitting, once the switches are in you will more than likely have to push it out from the back. ---The square hole one has NOT been tested I was asked to add it. Hole size is 25mm x 48mm---.