Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Phone Mounts

Jeep Wrangler JK Phone, Tablet and Gopro Mount Fully Printed

0 downloads1K views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

DaniRodes

Description

Fitment: Jeep Wrangler JK (2007–2018). Verify dashboard/base geometry, device clearance, fastener tightness, and sight-line clearance before driving.

I created this by mixing the projects from: https://www.thingiverse.com/unstuck/designs, https://www.thingiverse.com/wpvrtis/designs , https://www.printables.com/it/@Solomoriah , and https://www.thingiverse.com/jsrich69/designs . I recommend to print this with PETG or ABS, do not use PLA because it will not restist to the high summer temperature of your car. As shown on the pictures I added a rubber disc cutted from a bycicle tube and glued inside the arms, this will help to keep the mount very still. I uploaded 2 kinds of bases , one with a single hole for the original bolt, but for me wasn't enough so I added a version with 3 holes. In order to install this version you will need to driil 2 more holes and add 2 M5 bolt and nut. Hardware List: 4Cm M6 Bolt and Nut for Arms. 7Cm M6 Bolt and Nut for the base (I was not able to find 7Cm, so I cutted a 8 Cm Bolt). 4Cm M5 Bolt and Nut for the Gopro mount ann knob. 4Cm M4 Bolt and Nut for the Quadlock mount. Obviously, you can change the Quad Lock mount with the one you like. For any question just leave a comment!