Jimny rear door lever cover

0 downloads58 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

Source link only

No hosted model files

Material start

PETG or ASA for durability and heat resistance

Saved part guidance

Strength start

20-30% infill for a balance between strength and weight

Saved part guidance

Orientation / supports

verify in slicer

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

Cabin/interior use; avoid high-heat zones

Download the model at its source, then confirm the format is supported by your slicer. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

Download at source

License & use

CC BY-NC-SA

Link-only

Attribution required

Files stay with the original publisher; this catalog entry does not grant hosting or resale rights. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

*German below* Cover for the opening leaver for the rear door of a Suzuki Jimny FJ, with or without a oval cutout to acess the lever, in either 1,5 or 2,5 mm thickness. Remove the factory plugs from the square holes and just push the cover in place, you may have to modify the rectengular studs a tad to make it fit. The cover is interferencefit. ________________________________________________________________________ Abdeckung für den Türgriff der Hecktüre von einem Suzuki Jimny FJ, mit oder ohne ovalen Ausschnitt in 1,5mm oder 2,5mm Dicke. Einfach die Stopfen entfernen und die Abdeckung reindrücken, eventuell müssen die Pins auf der Rückseite etwas nachbearbeitet werden, das Ganze is Übermaßpassung.