Files (1)
Reference shelf
Recommended filament for this print
Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.
| Referenced item | What to verify | Price & availability |
|---|---|---|
| PETG filamentAmazon · Affiliate link | Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region. | Check price at Amazon |
| ASA filamentAmazon · Affiliate link | Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability. | Check price at Amazon |
Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.
Land Rover Discovery 1 & 2 Cup Holders
License & use
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
3DPrintedCarPartDescription
Similar to original cup holders but a completely new design with extra features. I've removed the slot for a handle as this was never used by takeaway cups. Removed the insert to allow for larger cups up to about 80mm diameter TPU spokes keep a cup upright and more secure, even smaller cups Large threaded base screws to the holder to prevent lifting Top ring screwed in position to make the TPU ring replacable I've used countersunk M3 x 7 screws to lock the top ring and TPU in place. I've included an alternative ring that takes M3 x 7 cap head screws if you prefer. The base needs to be printed upside down with supports to the build plate. The remaining parts can all be printed without supports. All parts should load into your slicer orientated correctly. I printed PLA at 10% gyroid infill and 4 walls (with Cura) Rubber ring printed in 95a TPU You will need two small wood screws to attach this the plastic transmission tunnel of the Discovery 1 or 2. The holes should be in the same location as an original cup holder or previous clones.
Compatible Vehicles
Originally published on printables.com by Pugwash · License: CC BY
Browse categories
Browse other part families
Jump to interior, exterior, accessories, dashboard, mechanical, or tools hubs when you need a different kind of replacement part.
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Most specific car + model + year + category matches first, with popular parts mixed in.
