Landrover Discovery 5 Phone Bracket - image

Files (1)

Disco_phone_bracket.stl

STL

3.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	ABS / ASA 20%	ABS / ASA 25%	100% solid	Recommendation
Disco_phone_bracket.stl	Mount / bracket	3.6 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Land Rover Discovery 5 Phone Bracket

0 downloads39 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

ABS or ASA for durability and springiness

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for a balance between strength and weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Higher-heat material; verify location and load

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This bracket allows your mobile phone to fit in the optimum place in the vehicle tor good reception and viewing. It clips into the horizontal wood effect strip that runs across the width of the dash. best printed in ABS because its springy and the clips work better - once this is fitted it stays put. You need to use a phone holder to bolt to this bracket, I used a Samsung wireless charging bracket but there's cheaper ones that work fine - couple of links below. https://www.amazon.co.uk/KUNCC-Wireless-Charger-Charging-Samsung-Black/dp/B07KM4W8BT https://www.ebay.co.uk/itm/2-in1-Qi-Wireless-Car-Charger-Magnetic-Air-Vent-Mount-Holder-For-Samsung-S8-S9/142623634634?hash=item213507f4ca:m:mtG3fZORmwiIjUxe1UZXqIA A big thanks to Allan Trottman and Albert for their help testing the designs.