Files (2)

Finished_V4_Driver_Side.stl

STL

1.2 MB

Finished_V4_Merge.stl

STL

1.2 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	ABS / ASA 20%	ABS / ASA 25%	100% solid	Recommendation
Finished_V4_Driver_Side.stl	Printable file	1.2 MB STL	Slice file	Slice file	Slice file	Print with the flat side face-down as recommended
Finished_V4_Merge.stl	Printable file	1.2 MB STL	Slice file	Slice file	Slice file	Print with the flat side face-down as recommended

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Door Handles

Miata Arm Rest Door Handle Plug

0 downloads43 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

2 hosted model files

STL

Material

ABS or ASA for durability in hot car conditions

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for strength and minimal weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Higher-heat material; verify location and load

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

My door plugs were falling apart so my brother and I decided to model them and make new ones. Print with the flat side face-down. Optional: Sand the flat-face smooth and spray with truck-bed coating paint for an OEM look with matching texture to the door handle. It should be noted that ABS works better especially if your car gets hot often, but I did use PLA ones for a while with no issues.