Miata Ash Tray Cup Holder Adapter - image

Files (4)

CupHolder.STL

STL

352.4 KB

CupHolderLeft.STL

STL

209.7 KB

CupHolderMM.STL

STL

352.4 KB

CupHolderRight.STL

STL

209.7 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

4 model files

Typical selected file

20g

Based on 25% main infill for the largest likely-needed model file

Material cost

$0.48

Filament only at roughly $24/kg PETG / ASA

Print time

34m–57m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
CupHolder.STL	Mount / bracket	352.4 KB STL	19g $0.45	20g $0.48	44g $1.06	Print with the faceplate side up for best results
CupHolderLeft.STL	Choose left variant	209.7 KB STL	15g $0.37	17g $0.40	37g $0.89	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.
CupHolderMM.STL	Mount / bracket	352.4 KB STL	19g $0.45	20g $0.48	44g $1.06	Print with the faceplate side up for best results
CupHolderRight.STL	Choose right variant	209.7 KB STL	15g $0.37	17g $0.40	37g $0.89	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

Miata Ash Tray Cup Holder Adapter

0 downloads36 views0 likes

Shared by

Alfred

Verified

Description

This is a new faceplate for the ahstray in older model miatas (NA models) to convert the ashtray to a cup holder. It is very secure because it uses the factory interface and it is swappable in case someone buys the car and prefers the factory parts. Simply pull out the ash tray, remove the 4 corner screws, and screw this plat in instead. I also included halves for anyone with a smaller print bed. Although you can print the halves and glue or acetone them together, I would recommend printing as one whole object if possible.