Miata plug for AFM delete

Decided to make this because I prefer this over spending 20€ and waiting 3 weeks or 50€ and waiting 3 days, turned out surprisingly well and decided to put it on here in case anyone else could make use of it. My print didn't turn out too well because my bed is warped to the point where my effective capacity has shrunk to a small square in the center. Use a low layer height for it, the print in the pictures had it set to 0.3 and you should probably use ABS for this. Once you got the wires where you want them you should put some hot glue over the top of the clamp thingies to truly keep everything in place, I originally intended for just the clamps to hold everything which they do well but because your print results will vary I'd recommend to just glue it in place. Legal disclaimer: I am not a licensed Mazda tech or any licensed anything for that manner, I will not be held liable for any possible damage that may occur to your vehicle or yourself during the installation or during operation.