Files (1)

Button_L300_v1.stl

STL

794.8 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

28g

Based on 25% main infill across listed model files

Material cost

$0.66

Filament only at roughly $24/kg PETG / ASA

Print time

47m–1.3h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Button_L300_v1.stl	Primary model	794.8 KB STL	25g $0.61	28g $0.66	60g $1.45	Ensure a tube wall of 1mm for the spring to prevent rattling

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

Mitsubishi L300 Sitz Knopf Seat Button/Knop

0 downloads53 views0 likes

Shared by

Alfred

Verified

Description

Ich habe den Knopf zum Verstellen der Armlehnen im Mitsubishi L300 nach Konstruiert. Leider bekommt man die nicht einzeln. Jetzt kann man sie sich einfach selbst drucken. Viel Spaß damit. Im Knopf ist im Original noch ein schlauch aufgestecht, welcher das Klappern der Feder verhindern soll. Wählt bitte eine Schlauchwand von 1mm. Die Feder hat einen durchmesser von: Außen: 1,05cm, innen: 0,9cm (0,95cm) -------------------------- I have redesigned the knob for adjusting the armrests in the Mitsubishi L300. Unfortunately, you can't get them individually. Now you can simply print them yourself. Have fun with it. The original knob has a kind of aquarium tube cut into it to prevent the spring from rattling. Please choose a tube wall of 1mm. The spring has a diameter of: Outside: 1,05cm, inside: 0,9cm (0,95cm).