Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Interior

New Beetle Armrest Delete

0 downloads189 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Jesse Barr (chyrio)

Description

Finally got around to making an armrest delete/coin holder for my New Beetle. Its not perfect but it conforms and is easy to install. Feel free to remix if if you can to suit your setup. I attempted printing in various positions. The best I found is laying it with the bottom of the piece flat, then adjusting the angle to make it perfectly flat on the build surface. Using this method you need to be careful when you pull the supports off that you don't break the clips off with them! I would highly recommend making this out of PETG or better since there's a chance of direct sunlight sitting in a hot car.