Nintendo Switch Holder for Tesla Model 3 - image

Files (1)

Holder_nologo.stl

STL

105.0 KB

Print plan

Exact totals not supplied

Print setup plan

Useful setup guidance without pretending STL byte size can predict filament, cost, or print time.

1 model file

Material plan

PETG / ASA

Published material guidance; still check heat, UV, load, and printer compatibility.

Starting setup

25% infill

A planning starting point only; wall count, orientation, and geometry often matter more than infill.

Final totals

Confirm in slicer

Slice the selected model with your final material, orientation, walls, and supports.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Reference shelf

Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Unsure which one fits? Read the automotive filament guide.

Nintendo Switch Holder for Tesla Model 3

0 downloads7 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

1 hosted model file

STL

Material start

PETG or ASA for durability and heat resistance

Saved part guidance

Strength start

20-30% infill for a balance between strength and weight

Saved part guidance

Orientation / supports

verify in slicer

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

License & use

Public Domain

Commercial use allowed

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

PLEASE be responsible and don't get yourself or anyone else killed. This is strictly for when the car is in PARK, just like Tesla Arcade. I take no responsibility for the misuse of this device. Again, THIS IS NOT FOR UTILIZATION WHILE THE CAR IS IN MOTION I was sitting at a Supercharging the other day and my wife wanted to play some Jeopardy while we waited. There was no good place to place the screen and this is what inspired this design. This dock has swing out arms that hang off the center screen. You will need to add rubber bumpers or thin foam to protect the back surface, top edge, and glass part of the screen. I used "cabinet bumpers" and the arms with recessed holes accommodate them. There is also arms for adhesive foam without the holes. You will need to print 2 arms and 1 dock. 7 bumpers needed or a couple square inches of foam. You can swing the arms around and essentially mount the dock upside down and you now have place to put an mobile phone (tested) or maybe even an iPad mini (not tested) or smaller tablet. Oh, and again: THIS IS ONLY FOR USE WHEN THE CAR IS IN PARK Enjoy!