Earn money selling original 3D car part models.
Start sellingEarn money selling original 3D car part models.
Start sellingEarn money selling original 3D car part models.
Start selling
Reference shelf
Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.
| Referenced item | What to verify | Price & availability |
|---|---|---|
| PETG filamentAmazon · Affiliate link | Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region. | Check price at Amazon |
| ASA filamentAmazon · Affiliate link | Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability. | Check price at Amazon |
Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
Lauri Rahtu (lauri_lr)This is a holder for Oneplus 5 and 5T with original case. It fits the original Oneplus charging cable and can be mounted directly to Brodit's tilt-swivel mount. The fit is very snug with 5T+case but also a slighly narrower Oneplus 5 fits well and doesn't fall off. The holder itself is a remix of gjlobb's design with a few modifications to dimensions and design to fit better with the clip and plate assembly. With the clip and the plate you can install the holder to Ford Mondeo MK4 (and probably several other cars, too) without any permanent marks on the dashboard. It is assembled using 4 screws. Everything were printed with PLA. I printed the clip with rafts and supports and 100 % infill. The plate and the holder were printed with 50 % infill without supports or rafts to make sure everything is sturdy.
Originally published on thingiverse.com by Lauri Rahtu (lauri_lr) · License: CC BY-SA
Browse categories
Jump to interior, exterior, accessories, dashboard, mechanical, or tools hubs when you need a different kind of replacement part.
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Other projects by us
Building tools that make life easier
Start a fitment, printing, or design discussion with this part already attached.
