Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Phone Mounts

Opel Astra Phone Holder

1 downloads188 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Jarosław Grządziel (jgrzadziel)

Description

I've designed this holder to be more suited for a smartphone in a case (etui) which makes it quite thick. It is easy to place and remove. If you need to make this holder more suitable for your phone, you can simply scale it a little bit (in a certain axis), or attach (e.g. by glue) some sticky material, to avoid phone falling out while driving. My phone fits perfectly, which means that it's easy to put in, but not prone to falling out. Printed in PLA+ which is a bit more resistant to temperature, but I will test if it melts if temps go higher:) Also I printed it in 0.3 mm - it was supposed to be just technical draft, but it's ok like that. Requires supports!