Porsche 718 Cayman GoPro mount

0 downloads68 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

Source link only

No hosted model files

Material start

PETG or ASA for durability and heat resistance

Saved part guidance

Strength start

20-30% infill for strength and minimal weight

Saved part guidance

Orientation / supports

verify in slicer

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

High cabin heat — validate PETG or choose ASA/ABS

Download the model at its source, then confirm the format is supported by your slicer. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

Download at source

License & use

CC BY-ND

Link-only

Attribution required

Safety/IP review

Files stay with the original publisher; this catalog entry does not grant hosting or resale rights. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a two piece mount for a GoPro clip in adapter to mount in a Porsche 718 Cayman. Slide the clamp over the bar behind the seats push in the clip and the slide in the GoPro adapter. It doesn't wobble and shouldn't slide. if it is a little loose the you could possible add a strip of electrical or similar tape to the inside of the clamp to reduce the clearance. The one shown was printed at 0.35 for speed but I would recommend 0.2 or lower if you want it to look good. The parts should be printed vertically and don't try and print too fast or it will most likely knock the part over on the print bed. I have added plain versions of each part without logos.