Rear cupholder for Tesla Model S

0 downloads56 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

Source link only

No hosted model files

Material start

PETG or ASA for durability and heat resistance

Saved part guidance

Strength start

20-30% infill for a balance between strength and weight

Saved part guidance

Orientation / supports

verify in slicer

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

Cabin/interior use; avoid high-heat zones

Download the model at its source, then confirm the format is supported by your slicer. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

Download at source

License & use

CC BY-NC

Link-only

Attribution required

Files stay with the original publisher; this catalog entry does not grant hosting or resale rights. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a rear passenger cupholder for Tesla Model S manufactured before September 2016, when rear cupholders became standard. The design uses two straps that slide under the armrest and are joined with the holder using small nails or paperclips etc. It requires no glueing to the armrest and can be easily removed. The holder folds upwards to give access to the ventilation controls behind. The cups are hollow enough to let the ventilation pass through without any issues. The holder itself might require some supports around the holes for the cups. Ps. If you like this design and are planning to buy a new Tesla Model S or X, then please consider using my referral link below, which will give you free Supercharging as long as you own the vehicle: http://ts.la/johan9011