Remixed Tesla Phone holder

I remixed this bracket so the phone could be higher and further to the left. This allow for a portrait or landscape mode. Since the phone was 'way out there', it kept falling off the screen so I added a passenger side bracket. The two brackets fit together with one single screw and there are NO attachment methods or modifications to the tesla screen. It just slips on and you snug up the screw to prevent vibrations. The weak spot is the ball arm as it gets all of the weight from the phone as well as the holder. So you will want to either print that entire arm with lots of infill, or use an overlap process to specify more infill for that ball joint. Cura does this with a 'support blocker' tool that you can convert to an overlap area. I tried to show two pictures of this. You will need to glue some of these pieces together. They are setup as mortise/tenon joints and provide a lot of support. Just make sure to let the glue dry fully before putting this against your tesla screen! Lastly, I used this motorized cell phone holder and it's pretty cool. Not only do the jaws open and close themselves, but this provides wireless charging as well. It was worth the $36 https://www.amazon.com/dp/B0932B387H?psc=1&ref=ppx_yo2_dt_b_product_details