Files (2)

bracket_right.stl

STL

34.1 KB

bracket_left.stl

STL

34.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 100%	100% solid	Recommendation
bracket_right.stl	Choose right variant	34.1 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 100% infill. Pick the matching side before printing.
bracket_left.stl	Choose left variant	34.1 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 100% infill. Pick the matching side before printing.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Saab 9-3 glove box bracket

0 downloads54 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

2 hosted model files

STL

Material

PETG or ASA for durability

Print time

Slice to calculate

Filament

Slice to calculate

Supports

supports unlikely

Infill

100% infill as instructed for strength

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC0

Commercial use allowed

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

Brackets to replace the broken brackets that hold the lid of the glove box of a Saab 9-3 from 2005. One picture shows the original bracket next to it. To create the part, print both halves 2x with 100% infill and glue them together with adhesive or thin double sided tape. This is done to allow easy printing without the need for support structures. Parts must be printed lying down on the biggest surface for maximum strength.