Files (1)

rev7.stl

STL

2.1 MB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

42g

Based on 25% main infill across listed model files

Material cost

$1.01

Filament only at roughly $24/kg PETG / ASA

Print time

1.2h–2.0h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
rev7.stl	Primary model	2.1 MB STL	39g $0.93	42g $1.01	92g $2.21	Ensure the model is oriented to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Saab 9-3 NG iPhone 6 holder

0 downloads50 views0 likes

Shared by

Alfred

Verified

Description

This is a Iphone 6 holder that is designed to fit to the Saab 9-3 NG. It has holes cut out for the charging port, the 3.5mm headphone jack and the speaker. The holder is designed to work with a iPhone 6 with a thin TPU case. A plain iPhone will fit but might sit somewhat loose. The holder fits with the snap on clip at the top of the dashboard to the right of the steering wheel. For more stability a double sided tape can be placed on the back. This was printed with PLA.