Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Phone Mounts

Samsung Galaxy S7 case/mount for Dodge Grand Caravan (2010)

1 downloads219 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Mike Bourgeault (mikebourgeault)

Description

My van has this useless hole in the dash. I came across an_da_liu's cool mp3 player designed to fit exactly in that spot and decided to make this. It took a few versions, including one that hard mounted the cellphone case to the part that goes into the dash (this needed support, LOTS of support, it looked like I had printed a brick.. This version is pretty good. It allows you to just lift off the phone, while in its case. A notch in the back of the phone case marries to a tab on the dash "cup" I added a small lip and a divider in the cup if one wanted still use it for change etc UPDATE - I modified the design of the phone case to strengthen the lower tabs. I think I got the holed in the right place and size to allow for most 1/8 plugs and charger plugs, while keeping the strength intact. I also separated in to two stl files.