Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Interior

Silverado Cubby Gauge Pod

4 downloads470 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Tyler Buras (BurasPrints)

Description

This is a gauge pod I designed for my 2005 Silverado 2500. It's the cubby just below the center dash vent. Not on all Silverado's though. Once you remove the old cubby, you need to remove the old clips which can be a pain. But are necessary to a good fitment in your truck. Replaces GM15766229 Cubby so check to see if this looks like yours. Gauge is a 2" and hole in center of part is angled to fit with the angled bezel. ( I am using a GlowShift and it fits perfectly with the bezel included with the gauge).