Single DIN Gauge Pod Cluster 50mm - MR2 - image

Files (1)

Guage_Pod_Cluster_V3_v5.stl

STL

207.5 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Guage_Pod_Cluster_V3_v5.stl	Primary model	207.5 KB STL	Slice file	Slice file	Slice file	Ensure proper fit by adjusting the bottom of the DIN slot as needed

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

Single DIN Gauge Pod Cluster 50mm - MR2

0 downloads49 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for durability in a car environment

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for a balance between weight and strength

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

Basic holder for 50mm gauges in a single DIN slot in an SW20 Toyota Mr2. If you still have the stock single DIN radio this space has a Toyota blanking plate. This will require some slight adjustment at the bottom of the slot to allow the gauges to fit. I was able to do this with a sanding bit on a Dremel quite easily.