Subaru Intake Component Body Clip

Intake component clips are used all over the intake system on many models of Subarus. These clips break easily and are fairly expensive to replace a single unit or buy a whole pack (considering after all... it is just plastic)... not anymore. The diameter of the clip is factory spec and fits a 7mm hole. The thread-type clip will open at the bottom when screwed in using a flathead to secure it in place... an identical mechanism to the factory clip. The top of the clip is 20mm and the factory clip is 19.9mm (not a noticeable difference in diameter), the shank is 13.2mm deep (factory size), the diameter of the shank is 6.8mm (factory size), and the threaded screw top measures in at 13mm in diameter (also factory size). Clip prints in two parts, outer and inner pieces print next to each other on the print bed and should not take very long to print. I recommend using ABS filament to withstand heat as PLA will most likely warp due to high engine temperatures but I will try both and update as I go along. This is an untested model but I will also provide an update as to whether or not the clip fits, secures, and holds up over time.