Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Mechanical/Functional

Suzuki Ignis key Base and Cup aligned

1 downloads240 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Stee Mad (steeod)

Description

It is a remake of key base to the clip section, the key cup dimensions correction, plus hole alignment. There are 2 hints about this model: 1. Don't forget to put inside, the immobilizer chip,in its specific section. In the original key you can access it, by removing the back cup. 2. There is some extra space, on right of key hole. It is needed to the let the key fit in. it should normally be filled with epoxy glue, after key fitting in the base. Have a nice day ( I hope you saved some money, as I did)!!