Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Phone Mounts

Tacoma Phone Mount

0 downloads455 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Mario Ricci (mtrtm)

Description

I wanted a phone holder for my 1997-2004 Tacoma that would allow me to stick on the magnet that came with my phone case: https://smile.amazon.com/gp/product/B08G8CTXBS I also wanted it to replace the screw for the Oh Sh*t handle on the driver side, so you can pop out the cover, unscrew the screw, and screw this back in. I'm not sure if the later ones have the same screw placement. I tested both a 30% infill and full infill, I think either of them will work. I have the 30% in my truck now. Of course, PETG or other heat-resistant filaments will work better for hot cars.