Files (3)

MountPost.stl

STL

2.4 MB

TeslaPlugHolder.step

STEP

287.9 KB

TeslaPlugHolder.stl

STL

29.4 MB

Print plan

Exact totals not supplied

Print setup plan

Useful setup guidance without pretending STL byte size can predict filament, cost, or print time.

3 model files

Material plan

PETG / ASA

Published material guidance; still check heat, UV, load, and printer compatibility.

Starting setup

35% infill

A planning starting point only; wall count, orientation, and geometry often matter more than infill.

Final totals

Confirm in slicer

Choose the needed variant, then slice it for grams, cost, and print time.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Reference shelf

Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Unsure which one fits? Read the automotive filament guide.

Organizers

Tesla Charge Cable Holder

0 downloads44 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

3 hosted model files

STL + STEP

Material start

PETG or ASA

Saved part guidance

Strength start

100% infill for the mounting rail, lower infill (e.g., 20-50%) for the cable holder

Saved part guidance

Orientation / supports

supports unlikely

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

Fits North American Tesla charge connectors. Designed to be printable without supports, both pieces should be printed with their backs flat against the build plate. I printed the mounting rail with 100% infill to prevent cracking from any over-tight screws. The mounting rail is designed for use with #6 screws, pan-head style (not countersunk) The mounting rail is also designed so that it could be mounted with a 3M Command Strip instead of screws. The fit between the rail and the cable holder was very snug on my printer; if it's too snug for you I might suggest a negative "horizontal expansion" value in Cura (or the equivalent setting in your slicer of choice) for the mounting rail piece.