Tesla Charger Organizer with separate logo insert and nub

TooMuchFun's design is by far my favorite of all the ones in Thingiverse. But as you can see from the comments on his original, a lot of people have trouble either getting the charger to fit or getting their plug stuck in the holder. There are lots of recommendations about scaling up the print. I tried that at first but found that the charger becomes too loose and can fall. After reading through some of the comments, I came to realize that the dimensions of the original design are perfect. The issue is the height of the nub at the bottom of the print. At first, I remixed it and reduced the nub height. But I quickly noticed that the bottom of my charger plug was getting marred. So I separated the nub and made it an independent piece. This gives you two options: 1. You can print the nub with TPU (I used a 95 shore hardness TPU - 10% infill, 2 walls) 2. You can experiment with the height of the nub until you find one that works best for your charger/printer/filament. I also separated the logo to make it easier to print in a different color. Tolerances for the nub and logo slots is 0.2mm, so you'll likely need to add a little CA glue to keep things put. Many thanks to TooMuchFun for the great design.