Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Organizers

Tesla J1772 Adapter Trunk Holder for Model 3/Model Y

0 downloads235 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Curtis Paris (hiopilot)

Description

In the Model Y, there wasn't a good place to store the J1772 adapter. This design uses the charger emergency release compartment of the M3/MY as a place to clip in a holder. This design adds a completely form fitting for the Tesla HPWC style connector. I've included the OpenSCAD model I built for the Tesla Holder portion. Finally, there is a Blender file that has all the pieces put together in case you need to adjust a cllp or re-use the holder design. ## Installation Instructions To insert the holder, you will need a little pressure (it fits very snug so it won't fall out). To remove the holder, pull down on the ring. It may require a pry tool as it's a very snug fit. ## Printing Notes Cura slicing. 0.2mm, Supports Required, 60% In-Fill Rotated to have the ring vertically. This is optimal print time, but, also provides strength and support for the clips.