Tesla Model 3 Door Handle Rubber Spacer - image

Files (1)

Tesla_Model_3_Door_Handle_rubber_spacer.stl

STL

45.1 KB

Print plan

Exact totals not supplied

Print setup plan

Useful setup guidance without pretending STL byte size can predict filament, cost, or print time.

1 model file

Material plan

TPU

Published material guidance; still check heat, UV, load, and printer compatibility.

Starting setup

15% infill

A planning starting point only; wall count, orientation, and geometry often matter more than infill.

Final totals

Confirm in slicer

Slice the selected model with your final material, orientation, walls, and supports.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Door Handles

Tesla Model 3 Door Handle Rubber Spacer

0 downloads106 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

1 hosted model file

STL

Material start

TPU

Saved part guidance

Strength start

15% infill

Saved part guidance

Orientation / supports

supports unlikely

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

Flexible material; verify heat and load

Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

On one of my door handles this rubber spacer was missing. The door handle was not flat on the car body and looked a bit strange. So I quickly designed this replacement part in tinkercad. Printing: Print with TPU, as slow and cool as possible (check for layer delamination) My best settings were: 200°C 10mm/s print speed 15% infill The print only takes 5 minutes.